|
Post by scoops on May 13, 2020 15:04:05 GMT
Anyone using a QR with their wheelrim(s)?
I had a bit of oversteer in the Superlight and using my Formula rim grabbed a whole handfull of air on opposite lock. So I'm getting a circular rim but want to be able to switch between the two easily hence I need a couple of QRs. I don't want to spend the earth for what will not be used very often but not heard good things about the £20 ones on eBay.
Any recommendations from experience?
|
|
|
Post by scoops on May 22, 2020 7:59:36 GMT
Went for the ultra cheap option and 3D printed one. Just waiting on a bike seat post clamp to complete.
|
|
|
Post by Si on May 22, 2020 9:34:09 GMT
Well with 3D printers you can always make a new one if it breaks. ...and I was looking at Demon Tweeks for you
|
|
|
Post by scoops on May 22, 2020 11:57:34 GMT
😄
Apparently PLA filament which this is printed from is OK so I’ll see how it goes. Depending when it breaks if it does I can get some carbon fibre impregnated PLA that is supposed to be absolutely rock hard.
Once I know it’s working if anyone wants one printed ask John 😂
|
|
|
Post by john7 on May 22, 2020 15:02:10 GMT
Simon, if you lived round the corner you would be tired of me
|
|
|
Post by Seven Smiles on May 23, 2020 14:39:43 GMT
Well with 3D printers you can always make a new one if it breaks.
|
|
|
Post by scoops on May 27, 2020 18:20:14 GMT
OK don’t bother 3D printing these with PLA.
Ordering two from Simracing Coach in aluminium as printer now on other duties
|
|